Jeep Wrangler JK 2007-2018 5 Stud Wheel spacer with 127mm PCD

Description 5 Stud Wheel spacers used for Jeep Wrangle JL These wheel spacers fits Jeep models like Wrangler 2006-2018 and Grand Cherokee 1999-current Does not fit Cheroke Overlander . Go to http://www.wheel-size.com/size/jeep/ to make sure these wheel spacers will fit your Jeep. NOTE: Price is per spacer! You can use these wheel spacers to push out the wheel a bit. Some people do it for the looks and others use wheel spacers because they fit new rims and the new rims catches the calipers. The wheels spacer bolts onto the vehicle on the existing studs with the nuts supplied. Your wheel then bolts onto the wheel spacer using the studs on the wheel spacer and your original nuts. Wheel spacer material ALUMINUM Stud - 1/2" 20 UNF - high tensile 10.9 grade Nuts - 40CrMo high tensile steel 30 mm thick (1.25") 127mm PCD Centre bore 71.5mm NOTE: Make sure you remove the assembly washers from the studs before you install the wheel spacers. They unscrew rather easily. They to not serve any real purpose. Notes: Please read full fitment instructions here: http://www.4x4direct.co.za/blog/fitment-instructions-for-wheel-spacers/ Make sure the surface on the vehicle hub is clean and free from any debris before fitment. The same applies to the back of the wheel spacer which should be clean. Tighten all nuts by hand first, then torque in cross over sequence to 30 Nm. Then Torque to 100Nm. When you have them fitted at a tyre fitment centre, keep an eye on the procedures because they normally tighten it with impact wrench. DO NOT allow them to use an impact wrench and make sure they tighten them in cross over sequence. Check the wheel spacer nuts after the first 500 km to make sure they are tight. Thereafter check every 5000km. * The use of thread locker will void the warranty of these wheel spacers Reason: How do you frequently check the torque if you used thread locker? Click here to confirm your Jeep's wheel size